FDLE Firearms Practice Test

These questions are part of the practice quiz. Start practicing

• Which of the following is not typically listed as a major handgun component?
• A double/single pistol is described as: the first round is double action, the second and subsequent rounds fire single action as the hammer remains cocked each time the slide cycles.
• Which statement about lubricants is most accurate?
• What are the basic cleaning steps for a semi-automatic pistol?
• After reassembling a pistol, what is the final check you should perform?
• What is sight alignment?
• What is the purpose of the Cylinder release latch on a revolver?
• Who is responsible for ensuring your weapon is securely stored when not in use?
• Which term describes the relationship between the eye, front sight, rear sight, and target?
• What should you do with dropped ammunition, speed loaders, magazines, or equipment until the range master declares it safe?
• What is the Case in a cartridge?
• Which of the following is an example of concealment?
• Which statement correctly reflects a core safety practice when handling firearms?
• What type of lubricant is described as non-penetrating and used on firearms?
• What best describes a striker-fired pistol?
• What is the proper procedure for a misfire or dud on the firing line?
• What safety procedure involves visually and physically confirming that a firearm is unloaded prior to passing it?
• Which statement best defines trigger control?
• Why is range safety essential for proficiency?
• What is recommended storage practice to prevent unauthorized access and accidents?
• Which statement accurately describes a malfunction?
• What is the correct hand placement phrase when drawing or returning the firearm to your holster?
• What is the approximate spread pattern of 00 Buckshot in a 2 3/4-inch shell?
• What is the term for the process of physically and visually verifying that a firearm is not loaded before handing it to someone?
• If you drop a firearm, you should reference which Florida statute?
• In the low ready position, the shotgun's barrel is held at approximately what angle to the ground?
• Which type of ammunition should be used from a reputable manufacturer?
• What protective equipment should be worn near the firing line?
• What term describes the results when the trigger finger pulls the trigger straight back with increasing yet constant and steady pressure until the firearm discharges?
• Use only which type of ammunition?
• For storing ammunition, you should follow which procedure?
• What is follow-through in shooting?
• Never unholster a firearm ________ the firing line.
• Which activities are prohibited on the firing line?
• Which technique is used when you cannot use the sights on your weapon or you have no time to align the sight properly?
• Which statement best describes essential range command etiquette on the firing line?
• Concealment is defined as which of the following?
• Deadly force does not necessarily mean that someone dies from the force used.
• What should you do to stay current with FDLE firearms requirements?
• What is the difference between imminent danger and potential danger?
• Complete the safety statement: Always treat every firearm as if it was ____ and ____ to fire.
• Which term describes the relationship of the front sight and rear sight with the shooter's eye?
• What is the purpose of a red dot or optical sight?
• What is the first step in basic cleaning of a semi-automatic pistol?
• Which component of a revolver is described as housing the extractor rod and containing the cartridge chambers?
• Threat recognition is the ability to distinguish a deadly threat from a non deadly threat.
• In a single-action pistol, what must happen before firing?
• What is considered safe storage and why is it important?
• Which statement best describes the Stand Your Ground concept in Florida law?
• What is the most important element of firearms training?
• Which cleaning patches are noted as absorbing more moisture due to being cotton?
• Double feed is a failure to extract the round in the chamber and a new round being fed the magazine.
• Which statement best describes the low ready position's purpose?
• Threat recognition is the ability to distinguish a deadly threat from a non deadly threat.
• What is a bore obstruction and why is it dangerous?
• For duty ammunition, which should not be used?
• Which shotgun ammunition is described as a standard 2 3/4-inch shell containing nine .33 caliber lead pellets, with a 3 inch magnum shell containing 12 .32 caliber pellets and a 20 inch spread?
• If you are unsure whether a firearm is loaded, what should you do?
• How do single-action and double-action triggers differ?
• What is TAP-RACK-BANG used for?
• Which statement best describes the revolver's cylinder operation?
• What steps should you follow when presenting a firearm for self-defense in terms of safety?
• Which activity is allowed on a hot range?
• If a misfire occurs during a deadly force encounter, immediately pull the trigger again.
• Which description best matches a squib load?
• Where should your finger be relative to the trigger guard?
• Factory-loaded ammunition is defined as being produced by which of the following?
• Which elements define sight picture when aiming a firearm?
• How do you perform a safe unload procedure on a semi-automatic pistol?
• Where should you never unholster a firearm?
• Which statement about a loaded magazine is true?
• Which sequence describes a safe unloading procedure for a semi-automatic pistol?
• In the context of firearm possession, what does civil liability refer to?
• In a standard 2 3/4-inch buckshot shell, how many pellets are typically contained in the shell?
• Before opening the cylinder, you should keep the muzzle pointed in a safe direction.
• The term handgun refers to which firearms?
• Which statement about a magazine safety (magazine disconnect) is true?
• Into what direction should you always point the muzzle?
• A red dot sight provides assistance in aiming by providing what feature?
• What is described by a failure to eject (FTE) or failure to feed (FTF) malfunction?
• Birdshot is normally used for which purpose?
• What is the function of a shotgun's recoil pad?
• Duty life refers to the recommended time ammunition remains reliable for what use?
• What factors contribute to reliable function of a firearm?
• What storage safeguards are recommended for firearm storage in homes with children?
• A misfire is when you pull the trigger and the hammer falls, but the round fails to detonate.
• What does Caliber refer to in firearms?
• Which activity is allowed on a cold range?
• When not actively using a firearm, where should a loaded firearm be left?
• When storing ammunition, how should it be stored relative to the firearm?
• Which statement is true regarding heat exposure for ammunition storage?
• Solvent and debris removal: With a clean, dry patch, wipe all parts again to remove the ________ and ________.
• What is Shot in shotgun ammunition?
• A squib load occurs when there is no powder or a partial burn of powder and the primer ignited.
• Which action is NOT a recommended practice?
• Cover is defined as what?
• In which stance is the low ready position typically used?
• Which item is NOT listed as a contributor to reliable firearm function?
• What does 'know your target and what lies beyond' require you to consider?
• In a firearm cleaning kit, which item is used to scrub the bore?
• What distinguishes a hot range from a cold range in terms of safety?
• What is a stovepipe malfunction?
• What term describes a malfunction?
• Failure to eject / stovepipe occurs when a fired cartridge case does not completely eject.
• To assume the low ready position, which description best matches the correct method for a shotgun?
• Gauge is defined as?
• Which statement best describes deadly force?
• In a double-action-only pistol, which statement is true?
• If a misfire occurs, what is recommended before retargeting?
• For duty ammunition, which should be avoided?
• What two-word principle guides your treatment of firearms?
• What is the difference between a loaded magazine and a loaded chamber?
• Which term describes the event when a fired cartridge case does not fully eject?
• Which cleaning accessory is designed to pull through and remove debris from the bore without disassembly?
• Which is an example of atmospheric heat exposure for ammunition storage?
• Gauge describes which aspect of shotgun bores?
• What are the fundamentals of marksmanship?
• Which revolver component houses the extractor rod and contains the cartridge chambers?
• Where should you typically carry or store a firearm while driving (per safety)?
• Which term describes a condition that prevents a firearm from operating normally?
• Which safety rule requires you to keep the barrel pointed in a safe direction?
• Phase 2 clearance refers to the process of clearing a double feed.
• Which statement correctly describes single-action operation?
• Which list includes the major components commonly found on most handguns?
• Before performing maintenance on a firearm, how should you verify that it is unloaded?
• Which statement describes the correct safe loading sequence for a semi-automatic pistol?
• Will there be a time when you will have to shoot with your support hand?
• What is the first step in performing a safe unload on a semi-automatic pistol?
• What is the purpose of cover versus concealment in defensive shooting?
• What instruction applies to retrieving dropped ammunition, speed loaders, magazines or equipment?
• Which statement correctly describes the risk of relying solely on concealment?
• Which option correctly identifies items to avoid when handling ammunition?
• Which statement best describes the difference between cover and concealment?
• Phase 2 clearance is how to clear a double feed.
• Which of the following is an example of concealment?
• What is the approximate effective range of a rifled slug?
• Which statement best describes the limitation of safety mechanisms?
• What two-word motto describes the proper attitude toward firearms?
• What is the function of the firearm safety mechanism?
• In a deadly force encounter, if you have access to a secondary weapon, which pair of actions is recommended?
• Which statement accurately distinguishes centerfire from rimfire ammunition?
• When is deadly force legally justifiable in Florida (high level)?
• In handgun grip terminology, the backstrap refers to which part?
• What type of lubricants should be used for firearms to avoid gummy buildup?
• How should your finger be positioned when not firing?
• When handling a firearm, which direction should the muzzle be kept to ensure safety?
• Where should the webbing of the shooting hand be placed when gripping the handgun?
• Birdshot is typically used for which purpose?
• Glock refers to their firearm as a _____________?
• When handling ammunition, which should be avoided?
• When the trigger is squeezed on a revolver, what sequence occurs?
• What should you do if a firearm is accidentally discharged in a public place?
• Which statement best describes civil liability in relation to firearms?
• What does dry-fire practice involve?
• A squib load is described by hearing a pop instead of a bang and feeling less recoil.
• During a safe unloading sequence, which step confirms the chamber is empty?
• Which principle supports both safe storage and responsible ownership?
• What is the purpose of a loaded chamber indicator?
• What is the primary purpose of muzzle discipline?
• What is the term for the rubber butt plate on a shotgun that reduces recoil?
• What is proper grip and stance to control recoil?
• Which statement about concealment is true?
• What is the difference between a hot range and a cold range in terms of allowed activities?
• Which statement about sights is correct?
• Why is hearing protection important on the range?
• How should you hand a revolver to another person?
• The ammunition you should use, according to guidelines, is which?
• Which statement best describes the difference between concealed carry and open carry in Florida law?
• In a double-action-only firearm, every shot is double action with the hammer at rest against the rear of the slide.
• An example of radiant heat involves ammunition stored in which location?
• What is the correct practice when presenting a firearm for self-defense to maintain safety?
• What does the term Safe Action describe in Glock pistols?
• Name two common firearm malfunctions?
• What is the low ready position?
• What happens when the hammer falls during revolver firing?
• Which combination of steps is required to verify that a firearm is unloaded before maintenance?
• Dry-fire practice is used to train which skills?
• What is the Florida concept of Stand Your Ground?
• Deadly force, as defined in the material, means force likely to cause death or great bodily harm.